1.1
Unfold the delivery arm.

1.2
Extend the arm to horizontal until it clicks.

1.3
Lift up the arm so that the vertical column extends out of the base.

(Start up & replenishment only)

2.1
Depress the blue on/off button.

2.2
Insert keypad into slot.

The display will show the authorization code / serial number for the device.

3.1
Have the 11-digit authorization code on hand.

3.2
Ensure the keypad card is fully inserted.

3.3
Enter the 11-digit Authorization Code and press "Enter".

Prepare the patient, following the clinical guidelines treatment protocol using the curing light inside the compartment.

5.1
The display will show the current balance.

5.2
Select "New Procedure" to do a whitening procedure.
(3 x 20 minute cycles).

5.3
Select "Continue" to proceed, "Abort" to cancel, and return to the main menu.

5.4
Once "Continue" is selected, the display will show the time remaining.

6.1
Grasp the delivery head with one hand and bring it close to the patient's mouth.

6.2
Use your other hand to raise or lower the arm to position the delivery head over the patient's teeth.

6.3
Use both hands to carefully "plug" the slender metal post on the delivery head into the hollow end of the optical positioner.

6.4
Have the patient bite down as the two parts join.

6.5
You will feel a slight "bump" as the delivery head plugs into the positioner.

7.1
Press the "Start" button to activate the light source.

The "Pause" button can be pressed at any time to turn off the light.

Press the "Continue" button to restart the light and resume treatment.

7.2
The control panel will indicate the current session number and time remaining.

7.3
Press the "Start" button to activate the light between gel applications.

(Fourth session option)

8.1
At the end of the third session, the display will read "Treatment Complete".

The operator can press "Done" to reset the device for the next patient or press "Extend" to go a fourth 20-minute session.

8.2
Press the "blue on/off" button to turn the unit off.